ClimateRight CR-2550 Manuel du propriétaire télécharger pdf (Page 103)

CHAPTER 4

4-10

As part of the direct current circuitry (DC for short) the engine features

a break

er with a reset button. This breaker protects the engine wiring

from overloads. Refer to the engine manufacturer’s manual for the

breaker location and operation.

In addition, there are fuses protecting the individual switches located

under the helm accessible at the port bow backrest or found under

the dash itself. See page 11. Always ﬁ nd the reason a breaker or fuse

fails and repair the problem before replacing the parts. Replace with

the same amperage and type breaker or fuse. Carry extra ones which

are available at marine supply stores or your closest Regal dealer’s parts

department.

DC Circuit Protection

Near the battery switch are several electrical components. One of the

items is a breaker normally 50/60 amps with a red reset button. This

breaker protects the main red power lead running up to the dash.

Main DC Breaker

The battery switch displays 2 functions; off and on.

Turn the knob to the “on” position before cranking

over the engine. Never turn the battery switch to

the “off ” position with the engine running.

The battery switch is located under the rear bench

seat on the starboard side of the cockpit. Since the

automatic bilge pump ﬂ oat switch and stereo memory are wired directly

to the battery switch you can leave the vessel and still have the vessel

bilge pump energized with the battery switch in the “off ” position along

with the stereo retaining its pre-set functions and stations.

Battery Switch