ClimateRight CR-2550 Manuel du propriétaire télécharger pdf (Page 99)

CHAPTER 4

4-6

Bilge Pump

This switch controls the bilge pump located

in the engine compartment. Mechanically, the

switch features a manual position forward and

an off position. When the switch is manually

activated the bilge pump sends the accumulated

bilge water overboard. There is an outlet on

the starboard aft hull where you can visually

monitor the bilge water.

The bilge pump uses an automatic ﬂ oat switch. In the “off ” position

the ﬂ oat switch activates the bilge pump as needed. This feature is

especially useful when the vessel is moored and vacant. There is a

built-in lighted icon on the bilge pump switch that illuminates when

the automatic mode is activated. The operator should monitor this

icon periodically while operating the vessel. If the light activates stop

the vessel and investigate the problem. Check the bilge pump before

each outing and remove any foreign objects caught in the ﬂ oat switch

or bilge pump grating. Never run the bilge pump in a dry mode since

it may shorten the pump life. The bilge pump is energized even with

the battery switch turned to the “off ” position.

Docking Lights

This switch controls the forward hull docking lights. They are very

useful for night maneuvering and docking.

Cockpit Lights

This switch controls the courtesy lights in the cockpit area. Using these

lights is especially useful for night boarding or exiting.

Accessory (Acc.)

This switch controls any after market equipment installed. Make sure

any components are matched to the over current protection (fuse).